Can Motorsport
Site Selection
CAN Motorsport
PRODUCTS
Contact Us
About Us
WIRED BY B
Can Motorsport
Site Selection
CAN Motorsport
PRODUCTS
Contact Us
About Us
WIRED BY B
More
  • Site Selection
  • CAN Motorsport
  • PRODUCTS
  • Contact Us
  • About Us
  • WIRED BY B
  • Site Selection
  • CAN Motorsport
  • PRODUCTS
  • Contact Us
  • About Us
  • WIRED BY B

MAXX STREET

 

Advanced entry-level engine control system for up to 6 sequential cylinders. Up to 12 in wasted spark

Faster and easier tuning with built-in wideband lambda and a built-in MAP-sensor up to 3 bar / 43.5 psi of boost.

Get started faster with the easy-to-use MTune PC-software

 

  • Aluminium casing
  • Boost control
  • Shift-cut
  • Internal loggings
  • Flex fuel
  • Advanced warning system
  • Built-in wideband lambda
  • Launch control
  • Anti-lag
  • 6 injector outputs (high impedance)
  • 6 ignition outputs
  • 4 extra outputs (GPO)
  • 4 extra analog inputs
  • 2 extra digital inputs
  • CAN bus (additional wires required)

Target engines for MaxxECU STREET

  •  All 1-12 cylinder engines (4-stroke)
  • Up to 6 cylinders fully sequentially
  • Up to 12 cylinders in wasted spark

MaxxECU STREET inputs

  • Intake air temperature sensor (IAT)
  • Coolant temperature sensor (CLT)
  • Throttle position sensor (TPS)
  • Lambda (WBO) sensor. Uses a sensor directly connected to the ECU without any additional electronics. Supports Bosch LSU 4.2, 4.9
  • 2 trigger inputs. VR or digital. Automatic trigger level detection. The signals are processed by a completely separated processor for maximum performance and immunity against interference
  • 2 extra temperature sensors. Can be used as switches or to control additional functions
  • 2 extra 0-5V inputs. Can be used for additional sensors such as for measurement of fuel/oil pressure
  • 2 digital inputs used for example for speed sensors (Hall) or switches
  • Built-in 400kPa MAP-sensor for up to 3bar/43PSI of boost

MaxxECU STREET outputs

  •  6 injectors outputs. High impedance only
  • 6 ignition outputs. 5V signal to drive ignition modules, CDI units or coils
  • 4 outputs for extra features. Can be used to control virtually anything. Fuel pumps, idle control, boost solenoids, nitrous, shift lights, fans, warning lights, etc. GPO 1-3 (2A), GPO 8 (5A)

MaxxECU STREET technical

  • CAN bus (additional wires required)
  • USB communication for tuning with MTune
  • 8MB memory for internal logging, up to 1000Hz
  • Supply voltage 8-22V
  • ARM Cortex-M3 120MHz main processor
  • Resolution on ignition: 0.1 degrees
  • Resolution on injectors: 0.001 ms
  • Updates the fuel and ignition calculations 2000 times per second
  • The fastest PC communication on the market
  • Weight: 520g
  • 140x134x42mm (including mounting points, excluding connector)
  • Aluminium casing

Downloads

MaxxECU STREET (REV9+) - Wiring-en (pdf)

Download

Copyright © 2025 Can Motorsport - All Rights Reserved.


Powered by

This website uses cookies.

We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.

Accept